Bush hammering on wedge-in Lavina plate for texturing and grinding concrete floors

• Bush hammer roller with 2 rows(30 teeth) or 3 rows (45 teeth) of carbide tips held by a metal frame bolted to a Lavina wedge-in plate.
• Conical carbide tips which are welded on the roller keep rotating and hitting the concrete floor to create the bush-hammered surface.
• The Bush hammer is a multifunction tool. Can be used to pulverize the surface of concrete floors to get aggregate exposure; or to create a rough hammered surface on used concrete floors for holding new layers of concrete or coatings like epoxy; for texturing and grinding concrete floors to create decorative finish like naturally weathered rock or anti-slip finish; or for coating removal, etc.

Z-LION bush hammer with a wedge-in plate for Lavina floor grinder for texturing and grinding concrete floors to get hammered profile. The special features of this tool are as follows:
• High-quality carbide tips (teeth) are used to make the hammer, with a long service life.
• Carbide tips are professionally welded onto the roller, extending the lifetime of the tool.
• The inside of the roller is made of a bearing, sleeve, and spring washer and is filled with grease. The roller always rolls smoothly.

• Wax is used to seal the roller to prevent dust from going into the bearing and stop the roller.
• Frame which to hold the roller bolted to Lavina wedge-in plate via 4 stout screws, no break under repeated hitting.
• The number and layout of teeth on the roller can be changed. 2 rows of 30 teeth or 3 rows of 45 teeth are both available. And roller can be replaced when carbide tips are used out.
• Special wedge-in backing plate fits Lavina grinders perfectly. Sliding in and out from the tool holder easily.